III. Operation
Operation of the DIGITEL™ Multiple Pump Control (MPC) can be controlled by the operator
through the system computer software. Refer to the system operator’s guide for specific
operating procedures.
Section 3 (page 15), Operation, contains the following information for manual control of the
DIGITEL MPC.
•
Front Panel Description identifies and describes the front panel controls and
indicators.
•
Rear Panel Description identifies and provides signal pinouts for the rear panel
connectors.
•
Operating the Ion Pump explains how to evacuate and start an ion pump.
•
Using the Keypad provides a detailed explanation of keypad operation and its
associated display information.
•
Display Messages gives a description in a table format of the status messages that
can appear on the display.
•
Analog Outputs describes the monitor outputs for voltage and current.
•
Serial Interface provides detailed information concerning the computer
communication interface.
•
Menu Structure provides detailed flow chart on the menu structure.
Front Panel Description
Figure III-1 identifies the front panel controls and indicators on the DIGITEL™ MPC, which are
described in Table III-1.
HV
indicators
Display Select
keys
Display 1
Display 2
power
switch
Set Point
indicators (8)
Keypad
Display
Select
Display
Select
DIGITEL MPC - Multiple Pump Control
Supply 1
Set Point
Set Point
Power
1
2
3
4
5
6
7
8
High
Voltage
High
Voltage
1
2
3
4
5
6
7
8
9
ESC
0
ENTER
Menu
TSP
Bake
High
Voltage
Operate
Set
Points
Mode
Select
Supply 2
Figure III-1. Front Panel Controls and Indicators.
Digitel MPC Manual
Page 15 of 72
