You can specify the default pressure units to display: Torr, mbar, or Pascal. The bottom display
shows the units presently in use.
NOTE: This procedure does not change set point or TSP pressure values. For example, if you
have 1.5 mbar and change to Torr, then you have 1.5 Torr.
1.
Press the
Menu
key to cycle through the menu until you reach PREFRENCES.
2.
Press
ENTER
to step to the submenu selection PRES UNITS.
3.
Press
ENTER
again to display the units.
4.
An arrow points to the bottom
Display Select
key to show it is active. Press it to
cycle through the unit options — TORR, MBAR, and PASCAL.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
Display
Select
Display
Select
arrow shows
bottom key is active
Options:
- TORR
- MBAR
- PASCAL
press to cycle
through options
5.
When you reach the desired option, press
ENTER
to save your selection.
PUMP DSPLY - DFAULT VAL
You can specify the default display in voltage, current or pressure for Supply 1 and Supply 2
displays.
1.
Press the
Menu
key to cycle through the menu until you reach PREFRENCES.
2.
Press
ENTER
to step to the submenu, and press the Menu key to cycle to PUMP
DSPLY.
3.
Press
ENTER
.
4.
An arrow points to the bottom
Display Select
key to show it is active. Press it to
cycle through the unit options — VOLTAGE, CURRENT, and PRESSURE.
1
2
3
4
5
6
7
8
Set Point
Set Point
Supply 1
Supply 2
Display
Select
Display
Select
arrow shows
bottom key is active
Options:
-VOLTAGE
- CURRENT
- PRESSURE
press to cycle
through options
5.
When you reach the desired option, press
ENTER
to save your selection.
Setting Configurations
Overview
Press the
Menu
key to cycle through the top menu selections until you reach CONFIG. Press
ENTER
to step to its submenu. Press the
Menu
key to cycle through the following 12 submenu
selections:
•
FAN ON/OFF
•
POWER-LOSS RESTART
•
SERIAL ADR
Digitel MPC Manual
Page 32 of 72
