Game Composites GB1 GameBird, Maintenance Manual

Page: 92 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
24-27
Choose shielded wires from the table below:
Connectors, terminals and splices
1. Check condition of connectors for security and sign of overheating, causing poor connection between
wire(s) and pin(s).
2. Ensure all connectors are fully mated.
3. Check all contact pins are in position, no missing or misaligned pins.
4. List of connectors:
- Elevator trim servo connector, located between stabilizer and LH elevator
- Anti-Collision Lights connectors, located between LH wing and fuselage
- Aileron trim servo connector, located behind RH aft side panel
- Push To Talk momentary switches, connectors located on the bottom of each control stick
- Smoke switch, located on the bottom of the rear throttle quadrant assembly
- Trim control and indication, located behind LH aft side panel
- OAT sensor connector, located inside top end of LH landing gear leg fairing
5. Visually check condition of splicing of engine sensors.
Re-crimp as required, including when insulation is damaged.
6. Check sign of loose crimping of terminals. Replace as required.