Game Composites GB1 GameBird, Maintenance Manual

Page: 200 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
40-15
Fuel Flow Transducer
Electrical power for the Fuel Flow Transducer is provided through the Engine
Data Converter GEA 24, via the Battery Master (essential bus) and 2A EDC
circuit breaker on the circuit breaker panel, located in the RH side console in
the rear cockpit.
Location: Downstream from fuel pressure T-fitting,
LH side of engine oil sump
Type: Electronics International FT-60
Garmin PN 494-10001-00
Accessories: AN816-6 fittings
Manufacturer: Electronics International
63296 Powell Butte Hwy, Bend, Oregon 97701, USA
buy-ei.com
To service the Fuel Pressure Sensor:
1 Set Fuel Selector Switch to ‘OFF’
2 Remove cowling, refer to section 71-02
3 Remove / open Adel clamps supporting adjacent fuel lines
4 Disconnect electrical connection
5 Remove tie wraps, slide off fire sleeve
6 Disconnect fuel lines
7 Remove unit from airplane
8 Service or replace as required
9 To reinstall, reverse steps 3 – 7
10 Ground run in accordance with AFM section 4.4, 4.6, 4.11
11 Visually check for leaks
12 Install cowling, refer to section 71-02
Signature
13 Sign for correct installation
No regular maintenance is required for the unit. If defective, the unit must be replaced.
For wiring and connection details, refer to section 24-03
Troubleshooting or additional information:
Refer to Garmin G3X Touch Installation Manual, 190-01115-01_AE, available at
www.gamecomposites.com