Game Composites GB1 GameBird, Maintenance Manual

Page: 204 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
40-19
Manifold Pressure Sensor
Electrical power for the Manifold Pressure Sensor is provided through the Engine
Data Converter GEA 24, via the Battery Master (essential bus) and 2A EDC circuit
breaker on the circuit breaker panel, located in the RH side console in the rear
cockpit.
Location: Mounted with Adel clamps to
upper right main engine mount tube,
connected to Manifold Pressure port
on cylinder No. 5 via flexible hose
Type: Kavlico P4055-30A-E4A Garmin PN K00-00513-00,
Part of sensor kit
Manufacturer: Kavlico
1461 Lawrence Drive, Thousand Oaks, CA 91320, USA
www.kavlico.com
To service the Manifold Pressure Sensor:
1 Remove cowling, refer to section 71-02
2 Disconnect electrical connection
3 Unscrew sensor, remove from airplane
4 Service or replace as required
5 To reinstall, reverse steps 2 – 3
6 Switch on system, check for correct Manifold Pressure Indication:
Equals ambient pressure, compare with altimeter set to Zero
7 Ground run in accordance with AFM section 4.4, 4.6, 4.11
8 Visually check for leak
9 Install cowling, refer to section 71-02
Signature
10 Sign for correct installation
No regular maintenance is required for the unit. If defective, the unit must be replaced.
For wiring and connection details, refer to section 24-03
Troubleshooting or additional information:
Refer to Garmin G3X Touch Installation Manual, 190-01115-01_AE, available at
www.gamecomposites.com