Game Composites GB1 GameBird, Maintenance Manual

Page: 192 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
40-7
MFD 1
Electrical power for MFD1 operation is provided via the Battery Master (essential bus) and 5A MFD1 circuit
breaker on the circuit breaker panel, located in the RH side console in the rear cockpit.
Location: Rear instrument panel
Type: G3X Touch - GDU 465, 10.6" Landscape Display PN 010-01057-10
Accessories: GDU 465 Install Kit PN 010-12150-00
Manufacturer: Garmin International, Inc.
1200 East 151st Street, Olathe, Kansas 66062, USA
Tel: 913.397.8200
Fax: +1 913.397.8282
Aircraft on Ground (AOG) Hotline: +1 913.397.0836
www.garmin.com
To service MFD 1:
1 Use 3/32” hex key to remove all 4 mounting fasteners
2 Tip the top of unit approximately 3” backwards to reach the main connector
3 Disconnect electrical connection: unscrew connector fasteners, pull connector off plug
4 Remove unit from airplane
5 Service or replace as required
6 To reinstall, reverse steps 1 – 4 Signature
7 Switch ON Battery & Avionic Master to check function
8 Switch Avionics- and Battery Master OFF
Screen cleaning:
Clean screen with a clean, lint-free cloth (such as the Garmin cleaning cloth). Avoid any chemical cleaners or
solvents that can damage plastic components.
NOTE: Make sure that no dust or grit accumulates at the bottom of the display glass.
The GDU displays use infrared beams for touch detection, this makes it very important to
keep the screen clean, especially along the edges
NOTE: Replaced units must be formatted with Game Composites configuration software.
Contact Game Composites for details and support.
No regular maintenance is required for the unit. If defective, the unit must be replaced.
For wiring and connection details, refer to section 24-03
Troubleshooting or additional information:
Refer to Garmin G3X Touch Installation Manual, 190-01115-01_AE, available at
www.gamecomposites.com