49
28.2.3. Display of messages
The following messages are possible if the Advanced wireless communication module is being used. If
enabled in the menu the display backlight is switched on, too, so that it becomes apparent which
device is displaying a message.
Transmitting
data...
A remote access is currently in progress. The device is transmitting data to
the controller or the wireless USB modem.
Writing
data...
A remote access is currently in progress and data is written to the memory
of the G-Flame.
Remaining Range:
50%
A radio range test is currently in progress and the result is being displayed
(no bi-directional remote access but a range test as it is can be conducted
with the PFS Profi and as it has been also implemented in the PFC
Advanced to provide downward compatibility to devices of the Profi series).
Fire
Channel: 999
This is being displayed when firing commands are being received. If a flame
effect has been programmed for the firing cue the yellow 'Flame' LED goes
on in addition or it starts to flash if a step sequence is in progress.
RF Channel: 69
= 434.775 MHz
The G-Flame received the command to change the radio frequency. The
new radio channel and the frequency is being displayed.
28.2.4. Programming of the system ID
The G-Flame can be taught to different systems ID, just as it is possible with the Advanced receivers.
This procedure is called 'Teach-In' and is used if systems are split into several ones or if devices are
lent or rented out to other customers. After the return of the devices they can be e.g. taught to the
original system ID again.
To teach-in a system ID 'Up' must be activated while the device is in receiving mode and then the
command for the teach-in must be sent. Immediately after that the following confirmation message is
being displayed:
Teach-In
successful
The device will automatically return to the receiving mode after this
message.
28.2.5. The monitoring function Radio Interference
The G-Flames are monitoring their frequency permanently. An interference is present if an external
carrier with a signal strength of more than 30% in respect to 100% maximum signal strength of the
system is present for more than 45 seconds.
Radio
Interference!
This message is appearing if a radio interference has been detected. If the
display backlight has been activated the display will be illuminated
periodically, too. In this case it is advisable to check if the G-Flame has
been installed close to a strong source of interference. Therefore enter the menu item 'Interfering
Signal' and check if there is a higher value all the time.
By stepping through the menu with the magnetic pen the warning 'Radio Interference' will be cleared.
The device is always ready for use even if you do not clear this warning message.
Attention: If you switch on a G-Flame while the transmitter is in the firing mode the G-Flame will
display the warning message 'Radio Interference' soon. The PFS Profi and the PFC Advanced are
