33
22.3. The LED 'Charging'
This green LED is on as soon as the charging voltage is present and the battery is being charged.
With this indicator you can check if the charger is functioning properly. If the battery was completely
discharged it takes up to 30h for a full charge.
22.4. The LED 'Low Battery'
This LED starts to flash in red color in the receiving mode or respectively ready to fire mode if the
internal battery has been discharged below 30% and together with the flashes you will hear an
acoustic warning signal if the loudspeaker has been enabled. In such a case you should connect the
charger soon in order to charge the battery completely again. A full charge takes up to 30 h.
22.5. Functional check of the LEDs
Immediately after powering up the device a function test of the LEDs is performed. First the LED
'Operation' goes on for one seconds, followed by the LED 'Flame' and the LED 'Low Battery' while the
start messages are being displayed.
The LED 'Charging' can only be supplied by the charging unit and due to that this LED stays inactive
during the LED test sequence.
23. The warning LED 'Attention armed'
On one side of the housing where also the display and the connectors can be found there is also a
warning indicator in the shape of an exclamation mark.
This warning LED should alert people in the surroundings of installed devices that flame effects will be
possibly initiated.
In general this warning can be enabled or disabled in the menu of the device depending on whether
this function is desired or not.
Under which circumstances the warning will be displayed depends on the settings you have chosen
and various operation modes, providing that the warning LED has been activated in the menu:
Selected input
Warning while the safety
timer is counting down
Warning while the device is in receiving mode or
respectively ready to fire mode
Firing key
Yes
Yes, continuously
12-24V
Yes
Ja, ständig
DMX512
Yes
As soon as the safety channel is received with
values between 60% and 80%.
Serial data cable
(RS485 of the PFC)
No
As soon as the controller's command 'Firing
mode armed' has been received until the
command 'Firing mode disarmed' is being
received.
Wireless
(PFC or PFS)
No
As soon as the controller's command 'Firing
mode armed' has been received until the
command 'Firing mode disarmed' is being
received.
Note: When using a Galaxis controller for the correct function of the warning LED it is required that the
firing mode is disarmed when the G-Flame is put into operation. Furthermore the G-Flames must be
within radio range of the transmitter. On the edge of the coverage area or if radio inferences are
