27
17.2. Voltage input 12-24V
This input is intended to be used in conjunction with a Galaxis receiver or other firing modules.
The following Galaxis receivers can be used:
PFE Profi 3 Outputs and PFE Profi 10 Outputs
PFE Advanced 10 Outputs
Connect the positive output of the receiver with the red female input connector and the negative output
(ground) with the black female input connector.
The voltage input of several devices must not be connected among themselves to avoid equalizing
currents caused by different potentials. Instead either galvanically isolated outputs must be used or, if
several devices should be controlled by a single voltage signal a customized solution with a
galvanically isolated outputs must be used.
If using receivers of the Profi series you can select two different control durations (0.5 and 2.6
seconds). It is possible to initiate a firing cue several times one after another to generate several
consecutive flame effects. In addition you can re-fire the firing cue while the output of the receiver is
active to prolong the flame effect. With receivers of the Profi series it is not possible to program more
than one firing cue to one specific output.
If using receivers of the Advanced series with 10 outputs and Terminal function you may program as
many firing cues as required to each output and furthermore you can individually program the duration
how long the outputs should be active. This requires that the receiver is operated in 10 output mode.
Further explanation regarding the usage of the Terminal function can be found in the operation manual
of the PFE Advanced 10 Outputs.
If connecting other firing systems you have to pay attention that these devices have a DC output
voltage ranging between 12 and 24 Volts. Higher voltages can probably damage the input of the
G-Flame. In addition the equipment to be connected should not use capacitor buffered outputs and be
able to deliver a constant voltage. If you will be able to influence the duration of the flame effects
depends on the scope of operation of the control devices to be connected.
If necessary we are able to deliver accessory parts like banana plugs and control cables if you inform
us about your requirements. Also you can consult us regarding the technical suitability of other control
components.
