55
36.2. De-installation of the wireless module
Attention! Before you remove the wireless module it must be deactivated in the software of the
device. Otherwise the device can no longer be operated because the attempt to initialize the wireless
module is failing.
36.2.1. De-installation of the wireless module in the software
Switch on the G-Flame while you activate the sensor fields 'Up' and 'Down' by using two magnetic
pens until you see this being displayed:
Wireless Option:
On
You may select between 'On' and 'Off' with 'Up' and 'Down'.
Wireless Option:
Off
Select 'Off' in order to de-install the module, then activate 'Mode'.
After this 'Attention!' is being displayed in the upper line of the screen and below you will be able to
read the following ticker text:
Reinstallation is only possible with support
on the phone during the Galaxis office hours!
Subsequently the following safety request will be displayed:
Are you | Yes
sure? | No
Activate 'Up' if you really want to de-install the wireless module now.
Otherwise you can select 'Down' to exit the sequence.
Immediately after selecting either 'Yes' or 'No' the device enters the ready to fire mode.
36.2.2. De-installation of the hardware
Attention! Before you remove the wireless module it must be deactivated in the software of the
device. Otherwise the device can no longer be operated because the attempt to initialize the wireless
module is failing.
You can remove the wireless module by following the steps described in the section 'Installation of the
hardware' in reverse order.
37. Mounting on light or speaker stands
A receptor for the direct mounting of the G-Flame on light or speaker stands has been integrated in the
bottom side of the housing.
