295
6. Operation and maintenance
CAUTION
● Because the fiber layer on the back of
the A/C filter cannot be blown off with an
air gun, it cannot be cleaned and needs
to be replaced in time after getting dirty.
● Because the A/C filter is made of special
material, it shall not be washed with
water. Otherwise, dust will accumulate
and form clots, which will cause
decreased air volume of A/C or even
blockage.
PM1 filter SW302 No cleaning with high-pressure air gun
When installing the A/C filter, install it according
to the A/C filter down mark.
6.6 Replacing bulbs
Instructions for replacing bulbs
When replacing bulbs, be careful not to touch
the bulb glass with fingers. Otherwise, the
heat of the bulb will evaporate the grease on
the bulb from fingerprints and condense it on
the bulb glass, reducing the illuminance of the
lamp.
The working state of the lamp must be
checked after the bulb is replaced. Please go
to the GAC Motor authorized shop in time to
check the beam state of the lamp.
NOTE
● The vehicle lamps include halogen
lamps or LED. If the LED bulb is
damaged, please go to the GAC Motor
authorized shop to replace it in time.
● The removing and installing methods
of the left and right bulbs are basically
the same. Here only the removing and
installing methods of halogen bulbs on
one side are described.
Summary of Contents for EMPOW
Page 350: ...344 9 Environmental protection information...
Page 356: ...VI Index...