GAC MOTOR EMPOW, Manual, Page: 302 / 356

296
6. Operation and maintenance
CAUTION
The damaged bulb must be replaced with
a new bulb of the same specification. The
bulb specification of this vehicle => See
page 313 .
WARNING
If you are unfamiliar with the operation
process, safe operation specifications
and tool operation methods, do not
replace bulbs yourself.
● Turn off all lights before replacing
the bulb, and allow the bulb to cool
before replacing it.
● Pay attention to the sharp parts
on the combination lamp housing
in the engine compartment during
operation, and be careful not to
scratch hands while replacing bulbs.
Preparation for replacing bulbs
If it is found that any bulb is damaged,
replace the bulb as soon as possible. Before
replacement, make the following preparations:
1. Turn off all lamps.
2. Set the vehicle power switch to “OFF”
gear.
3. Check whether the related fuse is blown.
When the fuse is in good conditions,
perform bulb inspection and replacement.
Removing the rear combination lamp A
1. Switch off the vehicle power supply.
2. Open the trunk lid.
3. Pry off the fixing pegs and lift off the side
trim of the trunk.