Funktel f.airnet D5 Series, Operating Manual, Page: 26 / 160

26
Starting up D5 / FC5 Series
obliquely beneath the crescent-shaped holder on the narrow or long side.
The gold-coloured contact surfaces of the MEM card must face downwards.
The tapered corner of the MEM card must match the correspondingly ta-
pered corner of the MEM card slot.
 Press the MEM card downwards until the small retaining tab grips the card.
The retaining tab is always located opposite the crescent-shaped holder
As soon as an initialised MEM card that has been removed from a D3,
FC1, D4, FC4, IH4 or D11/FC11 is placed in the D5/FC5, the battery has
been installed and the handset has been switched on again, the follow-
ing applies ...
 The D5 / FC5 assumes the identity of its predecessor. It uses ...
 the login data of the previous D3, FC1, FC4, IH4 or D11/FC11
 the IPEI (International Portable Equipment Identifier) of the respective
predecessor
 The D5 / FC5 proceeds with the phone book on the MEM card as follows ...
 In the case of a D3 or FC1 MEM card, it takes over the phone book of
the MEM card and writes it to its own internal phone book memory
 If a MEM card of a handset of the D4, FC4, IH4, or D11/FC11 Series is
inserted in a D5 or FC5, then the phone book entries that are on the
MEM card are used without them being written to the internal telephone
memory (copying).
NOTE
Phone book management when operating with a D3 or FC1 MEM
card:
If you add to or change the phone book of your D5/FC5 on the hand-
set, these additions / changes are only performed in the phone book
memory of the D5/FC5. The content of the phone book on the MEM
card remains unchanged.
Phone book management when operating with a MEM card from a
D4, FC4, IH4 or D11/FC11 handset:
If you make an addition or change to the phone book of your D5/FC5