Fujitsu PRIMERGY TX1320 M1, Upgrade And Maintenance Manual

Page: 126 / 340

126 Upgrade and Maintenance Manual
TX1320 M1
Hard disk drives / solid state drives
7.2.4 Replacing a 2.5-inch HDD / SSD module
V
CAUTION!
●
Only remove an HDD / SSD module during operation if the drive is
not currently being accessed. Observe the indicators for the
corresponding HDD / SSD modules, see "FUJITSU Server
PRIMERGY TX1320 M1 Operating Manual".
●
Under no circumstances should you remove an HDD / SSD module
while the system is in operation if you are not sure that the drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
An HDD / SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
●
All HDD / SSD modules (drives) must be uniquely identified so that
they can be reinstalled in their original mounting locations later. If this
is not done, existing data can be lost.
7.2.4.1 Preliminary steps
Before replacing a 2.5-inch HDD / SSD module, perform the following steps:
Ê
Remove the hard disk drive cover as described in section "Removing the
hard disk drive cover" on page 59 .
Ê
Locate the defective server as described in section "Locating the defective
server" on page 44 .
Ê
Locate the defective HDD / SSD module as described in section "Local
diagnostic indicators on the front" on page 48 .
Only applicable for removing intact HDD / SSD modules:
Ê
Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
Customer Replaceable Unit
(CRU) Hardware: 5 minutes
Tools: tool-less