30
Service Supplement
Econel
50
Replacing the System Board
Replacement Routines
4.7
Replacing the System Board
Ê
Remove the left side cover, the system fan and the cross-beam, and fold out
the power supply unit as described in section “General Purposes” on
page 13.
Ê
Remove all cables from the connector panel.
Ê
Lay the server on the right side on a table.
Ê
Remove all cables which may be connected to the system board.
Ê
Remove all installed controller (for description see the Options Guide). Take
note of the slots of the controllers and the cabling.
Figure 21: Removing the screws
Ê
Remove the 10 screws from the system board.
Ê
Lift the system board slightly using the marked socket of PCI slot. In this way
you lift the system board out of the centering rings of the spacer bolts.
Ê
Carefully remove the system board (take the board with both hands) from
the casing at a slight angle. This allows you to pull the connectors out of the
connector panel.
Summary of Contents for PRIMERGY Econel 50
