![background image](http://html.mh-extra.com/html/fujitsu/primergy-econel-50/primergy-econel-50_service-supplement-manual_121056083.webp)
U41599-J-Z156-1-76
Options Guide
29
Controllers in PCI Slots
Installing a Low-profile PCI Controller
Ê
If required, connect the cables to the controller and other components.
Ê
Install the system fan as described in section “Mounting the System Fan” on
page 31.
Ê
Close the server, connect it to the mains, and switch it ON as described in
chapter “Completion” on page 31 and following.
I
Please check the relevant PCI slot settings in the
BIOS-Setup
. If
necessary, change the settings. Please read the documentation for the
installed PCI card.
Pay attention to the allocation of the PCI interrupts. You find further infor-
mation in the Technical Manual for the system board D1859 (PDF file
available on the
ServerBooks
CD).
7.2
Installing a Low-profile PCI Controller
The slots 1, 3, 5, and 7 are suitable for installing low-profile cards. These slots
are provided with two-piece covers. In order to install a low-profile card a part of
this two-piece cover is to be mounted as fitting bracket onto the slot cover of the
card.
Ê
Remove the slot cover from the PCI slot as shown in figure “Removing the
slot cover” on page 27.
V
CAUTION!
Keep the slot cover for further use. If the controller is removed again
and not replaced with a new controller, the slot cover has to be
reinstalled to comply with applicable EMC regulations and satisfy
cooling requirements and fire protection measures.
Ê
Unpack the new controller, and make the desired settings. You should read
the accompanying documentation supplied with the controller beforehand.
Summary of Contents for PRIMERGY Econel 50
