Fujitsu DESKPOWER 2000 FPC-M80000, User Manual, Page: 52 / 79

42
When connecting an internal hard disk that does not support the cable select function, configure
the hard disk as a master for master connection or a slave for slave connection.
Primary IDE
Secondary IDE
Third (master) *1
Fourth (slave) *2
First (master)
(hard disk pre-installed)
Second (slave)
*1: CD-ROM drive pre-installed. When a magneto-optical disk is selected as a custom-made option, however, a magneto-optical
disk drive is installed.
*2: CD-ROM drive installed when a magneto-optical disk is selected as a custom-made option.
Point
- For this PC, the lengths of cables differ between those to be connected to the primary and
secondary IDEs. Use a shorter cable (30cm) for connection to the primary IDE and a longer one
(45cm) for connection to the secondary IDE.
- By default, the pre-installed internal hard disk and CD-ROM are set to the cable select.
- Be sure to connect the hard disk that runs OS to the primary IDE connector as a master. If it is
connected as a slave or to the secondary IDE connector, OS may not run.
- For combination of the master and slave, refer to “Installing a device in the 5-inch front access
bay”.
<Primary IDE cable> <Secondary IDE cable>
Connect the option here to
configure it as a slave.
Connect the option here to
configure it as the master.
To the motherboard
SLAVE MASTER
30cm
SLAVE MASTER
45cm
Red line
06Panac(38-50) 01/11/2000, 09:23 42