Fuji Xerox ApeosPort-II C2200, Function Manual

Page: 27 / 137

Differences in the Copy Feature
25
Copy
3
Differences in the Copy Feature
This section describes differences from the copy feature written in the User Guide.
[Layout Adjustment] Tab
Edge Erase (Erasing Edges and Margin Shadows in the Document)
When you make copies with the document cover open or make copies from a book,
black shadows sometimes appear along the edges and center margin of the paper. If
it happens, you can make copies with the shadows erased.
Important • Confirm that the orientation of the document and the setting for [Original Orientation] are the
same.
Note • For 2-sided originals, the same edge erase amounts are set for the front and back sides.
• If you set [Reduce/Enlarge], the edge erase amounts will be reduced or enlarged in
proportion to the ratio you configured.
For information on the areas that can actually be printed, refer to “Printable Area” under “Chapter 16
Appendix” in the User Guide.
„ Normal
The edge erase amount is set to 2 mm for the top and bottom, and left and right. Select
one of [Margin Erase], [Edge Erase] and [Border Erase] to change the edge erase
amount.
„ Margin Erase
Erases shadows in the center of booklets or facing documents, or shadows at the top,
bottom, left, and light of documents. You can specify values for [Top & Bottom Erase],
[Left & Right Erase], and [Center] individually.
„ Edge Erase
Erases shadows in the center of booklets or facing documents, or shadows at the top,
bottom, left, and light of documents. You can specify values for [Top Erase], [Bottom
Erase], [Left Erase], [Right Erase], and [Center] individually.
„ Border Erase
Erases shadows in the center of booklets or facing documents, or shadows at the top,
bottom, left, and light of documents. You can specify values for [4 Edges], and [Center]
individually.
„ Erase Value
You can erase only the necessary amount. Specify the value within the range from 0
to 50 mm in 1 mm increments.
„ Original Orientation
The [Original Orientation] screen is displayed.
Refer to "Original Orientation (Specify the Orientation of Loaded Documents)" (P.26).