22
(3) Fuji Drive Assembly Instance
Output (from master to this option): o31=100
Instance
byte
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
0
-
X5 X4 X3 X2 X1 REV
FWD
1 RST XR XF -
-
-
-
-
2
Frequency command p.u. (lower byte)
100
3
Frequency command p.u. (upper byte)
FWD:
1 = Run forward command
REV:
1 = Run reverse command
X1 to X5:
Communication terminal block command
(The function to be performed is specified by E01 to E05).
XF, XR:
Communication terminal block command
(The function to be performed is specified by E98 and E99).
RST:
1 = Reset the alarm (fault) condition.
Frequency command p.u.:
Specifies the ratio of the frequency relative to the maximum frequency
(defined by F03 in Hz) being assumed as 20000.
Frequency command p.u. = Frequency command (Hz)/F03 (Hz)
×
20000.
Input (from this option to master): o32=101
Instance
byte
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
0 VL TL NUV BRK INT EXT REV FWD
1 BUSY
ERR
-
RL ALM DEC ACC IL
2
Frequency output p.u. (lower byte)
101
3
Frequency output p.u. (upper byte)
FWD: During
forward
rotation
REV:
During reverse rotation
EXT:
During DC braking (or during pre-exciting)
INT: Inverter
shut
down
BRK: During
braking
NUV:
DC link bus voltage established (0 = undervoltage)
TL: During
torque
limiting
VL:
During voltage limiting
IL: During
current
limiting
ACC: During
acceleration
DEC: During
deceleration
ALM:
Alarm relay (for any fault)
RL:
Run or speed command from communication enabled
ERR:
Function code access error
BUSY:
During function code data writing
Frequency output p.u.: Specifies the ratio of the frequency relative to the maximum frequency (defined by
F03 in Hz) being assumed as 20000.
Summary of Contents for FRENIC-Multi OPC-E1-DEV
Page 40: ...38 MEMO...
