Fronius Robacta Reamer Alu 3000upm, Operating Instructions Manual

Page: 60 / 92

Programme sequence and signal waveform on the
Robacta Reamer Alu Edition and Robacta Reamer
Alu 3000upm
Cleaning pro-
gramme se-
quence
CAUTION!
Risk of damage.
Do not start in automated mode until the cleaning device has been properly in-
stalled and started up.
NOTE!
Not coating the interior of the welding torch may result in permanent soiling of
the torch when welding begins.
Always wet the interior of the welding torch with the manufacturer's parting
agent before starting automatic operation.
Start
Wire cutter option
Start from position C
- approx. 25 mm (0.98 in.) next to wire cutter
- Speed: high speed mode
Pos. C
Start from position D
- approx. 25 mm (0.98 in.) Enter wire cutter
- Speed: 10 cm/s (236.22 ipm)
Pos. D
Wait 0.5 sec.
60