Freecom VALUELOADER DLT, User Manual

Page: 75 / 90

Diagnostics and Troubleshooting
Removing Stuck Cartridges
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 61
9
After removing the cartridges from the desired carriers,
reinstall each carrier on the ValueLoader belt ( figure 17 ).
• Make sure that the rollers on the bottom of the carrier are
aligned in the carrier tracks.
• Make sure that the belt post beneath each carrier is inserted
into the proper ValueLoader belt loop.
Figure 17 Installing
the Carrier
10
Ensure the carrier is properly installed on the belt by gently
pressing on the top of the carrier and sliding it back and forth.
If it is properly attached to the belt, it should not move. If it
moves, reinstall the carrier.
11
Replace the top cover of the ValueLoader and reinstall the
cover screws and mounting brackets (if rackmounted).
Note:
There are unused loops on the belt. The proper belt
loops have an extra bump on the outside of the loop.
See figure 17 below.