Freecom VALUELOADER DLT, User Manual

Page: 24 / 90

Installing the ValueLoader
Installing the ValueLoader into a Rack
10 ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
To install the ValueLoader, follow these steps:
1
Use a screwdriver to remove the two screws near the front on
each side of the ValueLoader.
2
Using the screws you removed in step 1 , secure one mounting
bracket (from the rack kit) to each side of the ValueLoader, as
shown in figure 5 .
Figure 5 Installing
Mounting Brackets
(Left Side Shown)
3
Using the screws and clip nuts from the rackmount hardware
package, secure one rail to each side of the rack in the location
in which you plan to install the ValueLoader.
• Be sure to secure both the front and rear of each rail to the
rack. The rails extend to fit a variety of rack depths.
• The correct orientation of the left rail is shown in figure 6 .
Repeat for the right rail.