FPM Agromehanika 408 D, Installation/Handling/Maintenance

Page: 35 / 66

2. Install the cover on the rear of the machine (on the flange of the output shaft).
PLOUGHING
For this purpose, you need the following connecting
devices:
a) - 1 plough with special attachment piece
art. number FPM 803 249
b) - universal connector for the motocultivator
art. number FPM 804 228
c) - 1 pair of wheel extensors
art.no. 501 93 110
d) - 1 pair of extra weights for the wheels
art.no. 501 93 111
e) - 1 pair - set of claws art. number 501 93 141
(depending on the land conditions)
INSTALLATION
1. Adjust the position of the steering column so that the engine moves forward, viewed in the direction of
travel.
2. Secure the drive wheels on wheel extensors and with a wheel spacing of 595 mm and 625 mm (see
technical data on page 20).
3. Install the additional weights of the wheels and fasten them.
4. Clamp the claws into the weights of the wheels and fasten the screws.
DANGER: Claws are only intended for work in the field, and you should not use them when
driving on the road.
5. Remove the rear cover from the motocultivator (shaft guard).
6. Center - secure the flange of the universal connector on the flotation flange.
7. Connect the dongle plug to the universal connector body.
8. Place the fuse stop on the universal connector in the appropriate hole.
(MIDDLE = NORMAL PLOUGHING, LEFT AND RIGHT = EDGE PLOUGHING)
WORK
1. Place the transmitter is placed in the "0" position.
2. Release the wheels of the wheel blocker lever so that both wheels are powered.
3. Start and warm the engine.
4. Pull the engine clutch lever and engage 1 degree of transmission, release the brake block lever (Pic.
11b).
5. Release the engine clutch handle slowly and at the same time give the gas.
6. During the first few meters of work, adjust the depth of plowing and lateral boundaries.
7. For turning at the ends of the furrow, use the wheel blocking lever (see description on page 18, Pic.
11a, b).
AFTER FINISHING PLOUGHING
The disassembly is done in the order opposite to that of the assembly.
PLOUGHING WITH A ROTARY PLOUGH
For this purpose, you need the following connecting
devices:
a) - Handpiece with special attachment piece