Picture 16
WARNING: Both sides of the wheels on the rims of
the wheels are used to fasten additional weights for
the wheels (see Pic. 16, item A).
INSTALLING THE CLAWS
The claws are pushed into the weights of the wheels
(see Picture 16,
item B) and fastened with screws (Pic. 16, Item 1).
DANGER:
The claws are only intended for work in the field and you should not
use them when driving on roads.
UNIVERSAL CONNECTOR FOR THE ATTACHMENT OF COUPLINGS
All traction couplings are connected to the base
machine in such a way that it joins with the
corresponding part (see Pic. 17, Item 1) on the
universal connector with its corresponding front part in
the shape of a three-hole triangle (Pic. 17, Item 2).
Securing the screws that are mounted on the
connector and tighten with the necessary torque.
Setting the tool (center - left - right) is done by moving
the locking pin (Pic. 17, Item 3). After adjusting the
tool, the shaft is secured with a fuse (Picture 17, item
4).
Setting the free tool (left-right) is done by unscrewing
and screwing the screws (Pic. 17, Item 5).
Picture 17
HANDLING THE MOTOCULTIVATOR
ELABORATION
You will do the best if you follow the following recommendations:
- During the first 50 hours of operation, the cultivator should only be used for easier work.
- During the first 50 hours of operation, you must not exceed the engine speed 2/3 of the
maximum.
- It is useful to occasionally intervene after every 10 hours of work, the motocultivator is loaded
with maximum load, but this does not last longer than 5 to 10 min.
- During the development period, and afterwards, avoid high speeds ("tuning"), as this can only
damage the engine.
- After the first 25 hours of operation, replace the oil in the engine. Further oil replacements
must be made according to the recommendations given in the section on "maintenance".
- After the first 25 hours of operation, replace the oil in the sweeper.
- Keep in mind that you always need to control the screws and nuts and, if necessary, tighten
them with the necessary tightening torque.
- Before starting the machine, check the oil level in the engine and the air purifier pot. The oil in
the air purifier pot changes depending on the condition of the dirt.
PREPARATION AND STARTING THE ENGINE
Before starting the machine, i.e. before starting the engine, you should check the following:
- Does the tank have enough fuel (see Picture 2, items 9 and 10).
3
2
1
4
B
1
A
Summary of Contents for 408 D
Page 42: ...FPM 805 229 FPM 805 160 FPM 807 167 strana 42...
Page 65: ...strana 43...
