FPM Agromehanika 408 D, Installation/Handling/Maintenance

Page: 25 / 66

After you have done all the preparations for starting the engine described on pages 22 and 23,
you can start the engine. In order for the engine to start easily, it is necessary:
IMPORTANT:
1. Start with an electric starter should not be longer than 10
seconds. If the engine does not turn on, wait 10 - 15 seconds and
repeat the procedure. If after 2 - 3 attempts of starting the engine is
not put into motion it is not necessary to continue with the further
switching of the starter, but first of all need to look for causes of
failure (fuel supply and similar).
2. Control the engine operation, the engine oil pressure indicator
(Pic. 20.2, Item 4), and the battery charging indicator light (Pic. 20.2,
Item 3). When the engine does not work both lamps are lit, and as
soon as the engine is turned on, they must be off. If the battery
charge lamp is faulty, charging is stopped (replace the incorrect light
bulb immediately).
3. The ignition key must not be pulled out while the engine is running
because it stops charging the battery.
STARTING THE HEATED ENGINE
To start a warm (heated) engine, proceed as stated in the "starting of the cold engine" section, but
you do not need to pull the extra charge control and the decompressor handle.
ELECTRICAL EQUIPMENT
Electrical equipment has 12V voltage, and includes normal or regular electrical equipment of the
engine and special lighting equipment. All consumers are secured through soluble 8A fuses, and the
entire installation is via the main fuse 25A. The fuse box is located below the sub-cultivator of the
motocultivator. To allow access to fuses, first remove the protective cover.
ACCUMULATOR
The power source for all electrical equipment is a 45 Ah battery and a 12 V battery. It is located
under the motor protection cover and the battery cover. In terms of maintenance, it is necessary to
take care that the electrolyte level in the battery should be 10 mm above the block: make sure that
the cells are not packed. The cleats should be clean, if clean, if they are oxidized carefully, clean
- The gas handle (fig. 20.1) is
positioned between ½ and max.
gas.
- You need to withdraw the Extra
Charging Command (see Figure
20, Item A).
- Put the key in the ignition switch
(figure 20.2, item 2).
- Pull the handle of the
decompressor and keep it in
tension (fig. 20.2, item 1).
- Press the "START" button (figure
20.5, item 5) until the end, after 3 to
4 seconds, release the handle of
the decompressor.
- - As soon as the engine is turned
on, let the "START" button return to
A
Figure
Figure
Figure