art. number FPM 804 131 - working grasp 1.05
m, or
art. number FPM 804 129 - working grasp 1.30
m,
art. number FPM 804 130 - working grasp 1.60
m.
c) - 1 pair of wheel extensors
art. number 501 93 110
INSTALLATION
1. Pre-assemble - connect a single-piece drive mechanism with a cutting device:
WARNING: You only have to do the following with a new mower, since you will
later remove the drive mechanism along with the cutting machine.
1. Mount the drive wheels on wheel extensors, with a 595 mm clearance for operation on flat terrain, with
a 625 mm clearance for working on sloping terrain.
2. Rotate the steering wheel handles on the machine so that the engine is backward when viewed in the
direction of travel.
3. Remove the cover on the machine (from the flange of the output shaft).
4. Secure the drive mechanism. Take care of both surfaces (clean and without lubrication on the
cultivator and on the drive mechanism, and the nuts are tightened on both sides evenly).
5. Install the additional weight and tighten the screw.
6. Insert the protective sheet into the front fixing (No. 3, page 36). and push the back support to the
intended location.
WORK
1. As with regular ploughing (page 32).
2. Pull the engine clutch lever and turn on R1 or R2 gear.
a) - Remove the protective sheet (number 5).
b) – Move the cutting rod to one side
c) - Attach the cutting machine to the drive
mechanism of the mower using the 4 screws,
and tighten the nuts with a wedge.
d) - Cut the knife back to its place, so that the
stone is lying between the panels on the back
of the wall. The masonry on the stone must be
facing upwards.
e) - Secure the spreader on the cutting edge of
the slit.
f) - Tighten the sheets to guide cutting on the
cutting machine.
1. Fixing nuts
2. Drive mechanism
Of the mower
3 Front fixing
protective sheet
4. Cutting
machine
5. Protective
sheet
6. Cutting
distributor
1
2
3
5
6
4
Summary of Contents for 408 D
Page 42: ...FPM 805 229 FPM 805 160 FPM 807 167 strana 42...
Page 65: ...strana 43...
