The drive shaft is independent of the gear and rotates from the rear of the machine when moving forward
(see "A" on page 10) to the right (or see Picture 7, with the label on page 15).
The shaft rotation speed is 818 min-1.
If the steering column rotates by 180º, so that the engine is in the rear when viewed in the direction of
travel, then the pivot shaft from the rear of the machine turns to the left.
IMPORTANT: If the drive shaft should be switched on for stationary operation, the gear shift lever (see
Picture 7, page 15) must be set to stand by, i.e. to "0". Also, due to the safety lever, switch on the slow
travel - fast travel speed in the neutral position (see Picture 8, Item A).
WHEEL BRAKES
Picture 10
Activating the brakes independently one from the other is achieved via the brake lever (see Pic. 10, pos.
A and pos. B), which is mounted on the steering wheel, and via the control cables.
The lever is not activated when in the forward position (see arrow, Pic. 10), while pulling the lever
towards the operator (downwards) activates the brake shoes on the drum.
CAUTION: THE BRAKE HANDLE SHOULD BE PULLED CAREFULLY TO PREVENT
SURPRISES IN THE USE OF THE MOTORCULTIVATOR.
WHEEL BLOCKERS
This machine is equipped with brakes which are at the
same time parking brake. The brakes are equipped
with internal brake shoes which act simultaneously at
both drive points, if you activate simultaneously the
two brake levers.
IN DRIVING WITH THE
TRAILER, INDEPENDENT
ACTIVATION OF ONE FROM
THE OTHER POWER POINTS
IS FORBIDDEN.
CAUTION
:
A
B
Summary of Contents for 408 D
Page 42: ...FPM 805 229 FPM 805 160 FPM 807 167 strana 42...
Page 65: ...strana 43...
