FPM Agromehanika 408 D, Installation/Handling/Maintenance

Page: 19 / 66

causes difficulties in working with the
machine. For this, pay attention to these
instructions.
CAUTION: We recommend that when you need to adjust the brake cables for the first
time, your FPM AGROMEHANIKA AD Boljevac service provider should
explain and show the correct adjustment of the cables.
TURNING THE COLUMN OF THE STEERING WHEEL
Picture 13
The entire steering column can be turned and
placed on the left or right side, and in addition to be
turned 180º and positioned for both operating
directions of the machine.
CAUTION: Turning the steering column can only
be done by turning to the opposite side of the one
on which the exhaust pot is located (according to
the label on the mask).
Turning the steering column for 180º is done as
follows:
a) - Set the lever to the "0" position.
b) - Pull out fuses and levers (Pic. 13, Item 2) from
the speed change lever, the shaft lever and the
slow-fast travel switch, and push these levers
backwards.
c) - The handle on the steering wheel (item 1,
Picture 13) for adjusting the steering column
should be squeezed by hand.
d) - Rotate the steering column. You can take a
180º turn around only on the side of the machine
on which the air purifier is located, in order to
prevent the twisting and damage of the cables of
the command.
e) - Release the handle now. 1, Picture 13) on the steering wheel.
f) - Reinstall the lever to »slow fast travel« and coupling ball bar to the appropriate brackets and secure
them with fuses.
g) - After fastening all the control levers, you should know that now, in the direction of travel, the gear
shift lever comes to the opposite side of the steering wheel (left side), and the handle for the command
"slowly" comes to the right side of the steering wheel.
ADJUSTING THE STEERING WHEEL TO A PRACTICAL WORKING HEIGHT
You can adjust the steering wheel to the required
working height using the handle on the steering
column (Pic. 14, Item 1). Moving the handle
1
2