-48-
Model UR-2 <Playback>
(6)
After you complete editing, use the [MENU] dial
to highlight "<SAVE>" and press the [ENTER]
key.
The edited start and end points are set and
the display returns to the chain play list
screen.
(1)
Use the [MENU] dial to highlight "[START]" or
"[END]" and press the [CUE/LOCATE] key.
The CUE list is shown.
<Note>:
To execute the following operation, more
than one CUE point must be set to the file to be
edited. Without any CUE point, you cannot ex-
ecute the following operation.
If you replace the start (or end) time with a CUE
time and then edit the CUE time, the replaced
start (or end) time is not affected.
Replacing a point with CUE time
You can replace the current start (or end) time
with a CUE time.
(4)
To edit the start time, press the [ENTER] key
while "[START]" is highlighted. To edit the stop
time, use the [MENU] dial to highlight "[END]"
and press the [ENTER] key.
On the screen, the frame digit of the start or
stop time flashes, as show below.
By default, the start time is set to the begin-
ning of the file (ABS 0) while the stop time is
set to the last recording time (REC END).
Flashing
Flashing
(5)
Edit the start or stop time.
Use the [MENU] dial to edit the value at the
flashing point. Use the [
] and [
] keys
to select the flashing point.
(3)
Use the [MENU] dial to highlight LN (list
number) "002" and press the [ENTER] key.
The start and end points of the "008" file set
to list number 002 are shown.
<CUE list screen when selecting "[START]">
<When selecting "[START]">
<When selecting "[END]">
Summary of Contents for UR-2
Page 95: ......
