Fortinet FortiMail-100, Install Manual

Page: 58 / 174

Inserting a FortiMail board FortiMail-5001A hardware installation
FortiMail™ Secure Messaging PlatformVersion 4.0 Patch 1Install Guide
58 Revision 2
http://docs.fortinet.com/ • Feedback
6 Insert the FortiMail board into the empty slot in the chassis.
7 Carefully guide the board into the chassis using the rails in the slot.
Insert the board by applying moderate force to the front faceplate (not the handles) to
slide the board into the slot. The board should glide smoothly into the chassis slot. If
you encounter any resistance while sliding the board in, the board could be aligned
incorrectly. Pull the board back out and try inserting it again.
8 Slide the board in until the alignment pins are inserted half way into their sockets in the
chassis.
9 Turn both handles to their fully-closed positions.
The handles should hook into the sides of the chassis slot. Closing the handles draws
the FortiMail board into place in the chassis slot and into full contact with the chassis
backplane. The FortiMail front panel should be in contact with the chassis front panel.
Both handles lock into place.
As the handles close, power is supplied to the board. If the chassis is powered on the
IPM LED starts flashing blue. If the board is aligned correctly, inserted all the way into
the slot, and the handles are properly closed the IPM LED flashes blue for a few
seconds. At the same time the STATUS LED flashes green, the interface LEDs flash
amber, and the ACC LED starts flashing green. After a few seconds the IPM LED goes
out and the FortiMail firmware starts up. During start up the STATUS LED may
continue to flash green. Once the board has started up and is operating correctly, the
front panel LEDs are lit as described in
Table 2 .
If you have installed an AMC module in the FortiMail board, the AMC LEDs are lit as
described in
Table 3 .
Table 2: FortiMail normal operating LEDs
LED State
ACC
Off (Or flashing green when the system accesses the FortiMail flash
disk.)
OOS
(Out of
Service) Off
Power
Green
Status
Off
IPM
Off
Handle
Alignment Pin
Open
Alignment Pin
Lock
Handle