Ford Falcon (FG) 2010, Manual

Page: 41 / 264

-41-
To train keypads
Note:
Old keypads are removed from
the system memory during the training
procedure. Ensure all keypads are
available to be retrained at the same
time (old and new).
1. Switch the ignition from the OFF to
the ACC position.
2. Press the rear window demister
button 3 times within 5 seconds.
The door locks will cycle to indicate
that the system is in training mode.
3. Press any button on the keypad to
be trained. The door locks will cycle
to indicate that the keypad has been
trained.
Note:
The first keypad trained will result
in one door lock cycle; the second
keypad trained will result in two door lock
cycles, etc.
4. Repeat Step 3 for all other keypads
to be trained. Turn the ignition OFF.
The door locks will cycle to indicate
that the training mode has been
exited.
Replacement batteries
If the range of the transmitter in the key
decreases gradually, the battery
should be replaced.
WARNING
Take care when using hand
tools to avoid personal injury. Do
not push tool parts inside the body of the
remote control or damage to the internal
circuits may occur. Keep the old battery
out of reach of children and dispose of
responsibly. If in any doubt, your Ford
Dealer will be happy to change your
battery for you.
Locks and security
Flip key battery replacement
1. Press the release button to flip the
key blade to the open position.
2. Insert a thin screwdriver as far as
possible into the second slot from
the base of the key and push it
towards the key blade to release the
container from the key blade.
3. Separate the key blade component
from the keypad container.