39
15. Electrical schema
Figure 49 – Electrical schema
16. Troubleshooting
Apparent malfunctions are often caused by incorrect operation. If you think something has gone wrong with your
stove, check out the points below. If the trouble is not remedied after checking these points, then contact your
installer.
Problem
Possible causes
Correction
The stove gives off a lot of
smoke.
1. Damp or green firewood.
2. Chimney needs cleaning.
1. Burn drier firewood.
2. Clean the chimney.
The stove takes a long time
to heat up.
1. Damp or green firewood.
2. Chimney needs cleaning.
1. Burn drier firewood.
2. Clean the chimney.
The fire is not sustained
during the night.
1. Insufficient firewood in the stove.
2. Too soft firewood e.g., pine.
3. Door incorrectly adjusted.
1. Fill the stove with firewood.
2. Use heavier firewood.
3. Replacing the fibreglass rope.
Fire goes out.
1. Damp or green firewood.
2. The stove has not been heated suffi-
ciently.
1. Burn dry wood or open the combustion air
control further.
2. Heat the stove thoroughly before closing the
combustion air control.
Glass gets dirty
1. There is no soft flame.
2. Damp or green firewood.
1. Open the combustion air control further.
2. Burn drier firewood.
Power cable
3 position button
Resistance Thermostat
Microswitch
Fan
Plug
Summary of Contents for E601
Page 65: ......
