Fogo Montanha E601, Instruction Manual

Page: 13 / 65

13
6. The table must be levelled as accurately as possible with the aid of a level. Tighten all screws with a 6 mm
umbrako wrench. Move the brackets on the back wall and mark the holes. Remove the brackets, if necessary,
remove the screws and remove the assembly to facilitate the task of drilling holes in the wall. Once done is
placed the necessary components for fixing, put the brackets in place. Check that the table is level and the face
of the front wall, tighten the screws that hold the brackets to the table with a 6mm umbrako wrench.
Before finalizing the installation check if the table is levelled and if necessary, correct it.
Figure 7 - Auxiliary table assembly
7. After fixing the table to the floor and wall, you should drill the holes for FIP bushing M8x60 Ø10mm
Chemical, for the upper supports "PA1090G053", according to the indicated measures, see Figure 8.
Figure 8 - Mounting the upper brackets
Equipment A
(mm)
B
(mm)
C
(mm)
E901 520 841 2
E801 520 741 48
E701 520 641 2
E601 520 541 48
E909 680 841 2
E809 610 741 48
E709 538 639 0
E609 470 539 49
Fixing to the wall.