Operating Manual BKS309.MS
14.08.2018
8
4
Installation
Caution
Proper function of the FMS web guides and actuators is only guaranteed with the
recommended application of the components. Other arrangements, can cause
heavy malfunctions. Therefore, the installation instructions on the following pages
must strictly be followed.
Caution
Local installation regulations are to preserve safety of electric equipment. They are
not taken into consideration by this operating manual. However, they have to be
followed strictly.
4.1
Mounting the Steering Frame
The mounting orientation of the steering frame (indicated by an arrow), must
correspond with the web running direction. The lower frame is mounted with four M8
screws to the machine frame. The machine must be prepared to accept the M8
mounting screws.
4.2
Mounting the Actuator to your Unwind or Rewind Station
The static part of the winderGLIDE actuator must be mounted to the machine frame
e.g. to the spherical rod end on the gearbox. The moving rod end is mounted to the
winding stand. For other assembly forms consult the operation manual of the
BKS.D.3 respectively BKS.D.6. The BKS.D.3 / D.6 are designed for horizontal
mounting positions. The machine frame must be prepared to accept the mounting
devices of the winderGLIDE.
4.3
Mounting the Sensors
The sensors will be mounted with brackets to the rail of the steering frame or to the
sensor arrangement of the Master Web (refer to operation manual AZS01, US01 or
DLS). The sensors have to be installed after the steering frame if seen in running
direction of the web. They have to be mounted so that the narrow side is closer to the
steering frame (see Fig. 4).
Caution
The material sensors for the Master Web and for the Slave Web must both be
mounted on the same side (either left or right side).
