Operating Manual BKS309.MS
14.08.2018
10
5
Wiring Diagrams
Use the original FMS cables to connect the steering frame respectively the actuator
to the BKS309.MS controller. The connector end of the cable is connected either to a
steering frame or a BKS.D.3 / D.6 actuator. The open ends of the cables must be
wired to the cable terminals in the controller according to the wiring diagrams below
(ref. also to Fig. 5 or Fig. 7)
5.1
Wiring a Steering Frame with BKS309.R / .S or .W Controller
Sensor right = Master sensor
Sensor left = Slave sensor
Please note that both sensors must be installed either on the right or the left side of the
webs.
Fig. 5: Connection terminals BKS309.MSBKS309.ai
