Comark RF500A/AP Service Manual
Software Utilities
Software Utilities
RF500A Config Utility
This accompanying software is released to the customer to allow basic configuration of the unit via the USB interface.
Additionally it can provide a status report to aide fault finding.
To use the software Java 1.6.0 or higher must be installed, the installer can then be run and the utility will be installed
on the target machine.
Run the application with an RF500A/AP turned on and connected to the PC via the USB port, enter the serial number
and click “View Current Settings”:
No.
Item
Description
1
View Current Settings
View settings of unit
2
Software Issue
SW refers to the software issue currently running on the unit
HW refers to the firmware version currently running on the control MPU
3
Comms Port
This is the USB virtual com port currently being used
4
Generate Report File
Will output a text file with status information
5
Serial Number
Serial number of the unit to be interrogated
6
Save New Settings
Once new settings are entered in the relevant boxes this will initiate the
upload of those settings to the unit
7
MAC Address
This is the MAC address of the unit
8
IP Address
This is the current IP address of the unit (this can be changed and saved
back to the RF500A/AP)
9
Net Mask
This is the current Net Mask of the unit (this can be changed and saved
back to the RF500A/AP)
10
Default Gateway
This is the current Default Gateway IP address of the unit (this can be
changed and saved back to the RF500A/AP)
17 November 2011
Page 13 of 65
5
8
9
10
6
2
3
1
7
4
