19
8. Lifting up with the bag fitment, press the
center pin of the bag fitment valve and
gently press on the bag to release any
excess air.
9. Place the tray up-side-down over the bag
and pull the fitment into the tray opening as
shown. The grooves of the bag fitment
should slide into the tray opening.
10. Holding the fitment in place, raise the open
end of the tray and flip the tray right side up.
As the tray is set back down, allow the bag
to settle in the tray.
11. Make sure the syrup bag is settled neatly
into the tray, and then install the loaded tray
into the cabinet.
12. Once the Water / Syrup Flush process has
completed, disconnect the Pump Flush
nozzle from the Syrup Bag Connector.
Return the Pump Flush Adapter to its place
beneath the syrup trays.
13. Clean the exposed surfaces of the Syrup
Bag Connector and bag fitment with
detergent water, single service towel and
brush if necessary. Then rinse and dry the
Connector and fitment using clean water
and single service towels.
Summary of Contents for TS 80FCB
