29
7.2.1 Extruder Parts Diagram
7.2.2 Clogged Nozzle Cleaning
7.2 Extruder Maintenance Introduction
1
2
5
3
4
7
6
9
8
10
7
12
11
13
9
6
2
14
15
1. Left Extruder Upper Cover
2. Filament Feed Motor
3. Left Handle
4. Cooling Fan
5. Left Nozzle Assembly
6. M3*30 Hexagon Socket Button Head Screw M3*30
7. M3*6 Hexagon Socket Button Head Screw M3*6
8. Left Extruder Sheet Metal Shell
9. M4*3 Screw
10. Right Extruder Upper Cover
11. Right Extruder Sheet Metal Shell
12. Right Handle
13. Right Nozzle Assembly
14. Proximity Sensor
15. Cooling Fan
As shown in the above figure, the device is equipped with two extruders. According
to the direction, they are called the left extruder and the right extruder. The parts
and numbers related to the extruder assembly are consistent, but they are
left-right symmetric. Please note that they cannot be used interchangeably at will.
When operating the extruder, the power supply must be
disconnected.
Method 1:
1.
2.
3.
Heat the nozzle to the matching temperature of the filament used;
Pull out the filament guide tube, press the handle and pull out the filament;
Observe whether the head of the filament is bent. If so, cut off the bent part of
the head of the filament, then insert the filament guide tube and the filament
into the nozzle again, and click the [Load], and the nozzle will re-extrude the
filament.
Method 2:
Heat the nozzle and insert the unclogging pin tool into the throat and the nozzle to
extrude the filament inside the nozzle.
Left Extruder Assembly
Right Extruder Assembly
ATTENTION
