08
8. Click the -[Manual] on the screen, select the "No Fixed", press and hold
the , the Z axis will rise to about 100 to 120mm, and then take out the inner
pearl cotton;
9. Take out all pearl cotton and accessory boxes inside the equipment;
10. Use the accessory diagonal pliers to cut off the X-axis and Y-axis fixing ties (be
careful not to cut off the ties of the filament guide tube and the extruder harness),
and move the left and right extruders to ensure that they can move freely in X and Y
directions;
11. Adjust the casters at the bottom of the equipment, make it rotate clockwise, and
the foot pad will rise, so that the equipment can be pushed. Move the equipment to
the position to be placed, and then adjust the casters counterclockwise to fix the
equipment. At this time, the casters will not be able to rotate (when the equipment
is installed, the installation space size should not be less than
1400*1500*1600mm);
12. Install the Wi-Fi antenna. Take out the Wi-Fi
antenna from the accessory box, install it on the back
of the equipment, and screw it tightly. The position is
shown in the figure:
