8.Q&A
Q1. Clogged nozzle issue.
Q2. How to replace the nozzle?
32
Answer: Click the -[Maintain (Maintenance)].
Q3. Is there a need to calibrate the extruder after replacing the nozzle?
Answer: No.
Answer: Click the -[Maintain (Maintenance)].
Please shut down and cut off the power before replacing the
nozzle. Please do not operate with electricity.
Q4. Click to start printing the model, and the extruder moves, but there is no
filament extrusion at the beginning of printing.
Q5. The relative position between the nozzle and the platform is too high (far
away from the platform) or too low (touching the platform) during printing. How
to level it?
Q6. Can the filaments of other brands be used?
Answer: Click the -[Level and Calibibration]-Z calibration, and operate according
to the screen prompts.
Answer: The filaments of other brands can be used. But it needs parameter
adjustment and configuration due to the temperature difference of different filaments.
Q8. Can the equipment automatically shut down after finishing printing?
Answer: Yes.
Q9. Is printing ABS material safe?
Answer: ABS material will release toxic gases during heating, so it is recommended to
open the HEPA air filter for filtration during or after printing. If conditions permit, it is
recommended to place the equipment in an open environment for printing. It is
recommended to print PLA nontoxic materials in children's activity places.
Q7. Is the equipment compatible with all AC inputs?
Answer: The equipment is compatible with 220V-240V or 100-120VAC input voltage. If
the input voltage is different between different regions, it cannot be directly powered
on, that is, for countries with 110VAC voltage, it needs to purchase the equipment
corresponding to 110VAC voltage.
Answer:
1.
2.
Observe the filament guide tube to confirm whether the filament enters the
extruder; If not, please click the [Load] button again until the filament is extruded
from the extruder;
Check whether the nozzle is clogged. If so, please check the Q1 for the solution.
ATTENTION
