8
WASHSMART 685
Size setting
When a motor control module is replaced the machine when powered on will
display fault code 9 (required to be size set).
To set the size:
Turn the mains on at the supply and off at the console.
Touch and hold the
KEYLOCK
and the
Spin
buttons for 3 seconds until the
LED display shows the current setting of “- - -“or “685”.
To select the size touch the More
Button until “685” is displayed in the LED screen.
To save the setting power off the console with the
Power
button, your selection is
automatically saved.
Installation Test
Correct installation of the 685 washer is very important to the performance of
the machine especially the dynamics of the spin cycle. To aid with the
installation an install procedure P/No 421700 is attached on the top of the lid
of each machine, as part of procedure there is an installation test routine that
checks the water inlet hot & cold, drain and low speed spin of the machine.
The test routine will take approximately 3 to 10 minutes depending on the
supply water pressure.
With the console
Off
Press & Hold
Key Lock
and
Spin
for 3 Sec.
Size Setting Mode
6 8 5
To select Machine Size
With the console
On
Press & Hold
Key Lock
and
Options
for 3 Sec.
Installation Mode