37
02 Wash Level Overloaded (too full)
Possible causes:
1.
The product is overloaded.
2.
The user has selected the wrong water level for the load.
3.
The inner bowl assembly is jammed to the agitator with a foreign object
that may be caught under the agitator skirt.
4.
The spline drive and driven teeth are locked together with dirt, detergent or
lint.
5.
The spline drive and driven teeth are damaged / broken.
03 Out of Balance
Possible causes that need to be checked in the following order
1.
Even distribution of the load.
2.
The feet have the rubber inserts fitted and the cabinet base is clear of the
floor.
3.
The machine is correctly installed, level front to rear & side to side and
does not rock on the floor.
4.
The bias spring is fitted between the top of the neck ring and the rear left
hand suspension rod.
5.
The suspension is not catching or bouncy. If so, replace all four-
suspension rods.
6.
The weight of the inner bowl. The balance ring and bowl base of the inner
bowl contain water. The most accurate way is to check the weight of the
inner bowl (Refer to the
Inner Bowl Weight
Section).
7.
The holes in the inner bowl are not blocked and have been punched
through.
04 Suds Lock
This warning is generated if the machine senses too much drag on the inner
bowl.
Possible causes:
1.
Too much detergent generally causes this. If so, dissolve the suds by
flushing water through the machine and re-test.
2.
The pump is partially blocked, or the drain hose is kinked.
3.
A garment or foreign object is restricting the movement of the inner bowl.
4.
The main bearings are tight.