40
WashSmart 685
1 Touch the POWER button to turn on the console.
2 Touch and hold the button of the wash cycle you wish to customise
for 3 seconds.
E.g. REGULAR for 3 seconds. You will hear a beep and the display
will show “SEt” with the LED above the wash cycle button flashing.
3 Select your preferred setting, and any other options you wish to
customise for this cycle.
4 Touch the button of the wash cycle you are customising again,
E.g. REGULAR, to store your customised cycle (a long beep will
sound to confirm the changes have been saved).
Customising a wash cycle, e.g. Regular cycle
PRESET OPTIONS ADJUSTMENT
This is used to adjust the wash temp setting, the controlled cold setting, the
out of balance recovery, the end of cycle beeps and to reset the washer to the
factory defaults.
In this mode only 4 of the program cycles are selectable.
CleanSmart 685
To enter options adjustments mode
,
1.
Turn the machine on at the supply and off at the
console.
2.
Touch and hold the KEYLOCK and START/PAUSE
buttons for 3 seconds. You will hear 3 quick beeps
and the delay start LED will flash, indicating that you
have entered the mode,
3.
Use the program dial and buttons on the control panel
to make your changes to the pre-set options.