Maintenance Instructions
Seite/Page 116 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions
22.3.11
Fig. 6.10.2-5: Loosen fastening screws
Unscrew the fastening screws (Tool: Allen wrench SW6).
Fig. 6.10.2-6: Insert lifting screws
As shown, screw in 3 lifting screws M8x50 as far as possible by
hand.
Fig. 6.10.2-7: Pull off the bearing seat
Then screw in those 3 screws with a screw wrench SW13
equally and in turns.
By doing this, the bearing housing including the ball bearing and the shaft
sealing ring are pushed out of the generator cap.