
FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03
55
CHANGING THE TEMPERATURE
To display the set point, push and hold in the “
*
” button. The display (
Illustration 8.31
) will
alternate between the set point temperature and the temperature scale (
o
C for Celsius and
o
F for
Fahrenheit). To change the set point, push and hold in the “*” button and then press the “
▲
” or
“
▼
” keys to increase or decrease the setting. Release the buttons when done. Only make small
increment changes to the set point until the desired closure is achieved. Be sure to allow five to ten
minutes for the heaters to reach their optimum level before sealing bags in the PBC 6000.
Further information on options,
error messages and settings of the
temperature controller can be
found in the controller’s
Instruction Manual (in the
electrical enclosure). For
assistance please contact your
Fischbein representative or the
Fischbein Technical Service
Department (
page 3
)
8.10 DRIVE MOTOR AND GEARS
The PBC 6000 is powered by a drive motor, located above the compression area of the machine.
The motor is responsible for turning the drive shafts that power all of the belts. The shaft in the
fixed channel is directly connected to the drive motor. When the swing channel is closed, a set of
spur gears on the drive shafts mesh together, providing power to the swing channel system.
(
Illustration 8.7, page 32
)
The spur gears should be lubricated with grease at least once a month. The fasteners that connect
the motor to the channel should be checked to ensure that they are secured to the frame. Once the
fixed and swing channel shrouds are removed, the shafts, gears and blocks can be inspected for
loose fasteners. It is imperative that the gears remain across from each other and that the shafts are
parallel to each other, when the swing channel is closed.
After normal usage the bearings for the drive shafts may need to be replaced. If the drive assembly
needs replacement, please contact your Fischbein representative.
Illustration 8.31
Summary of Contents for PBC-6000
