FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03
54
TESTING and the AUTOTUNE FUNCTION
16. Turn the pneumatic and electrical systems “ON”. Close the swing arm and check the
cartridge lead wires to make sure they are not interfering with any components.
17. Turn the heaters “ON”.
18. AUTOTUNE: To run the Autotune feature, press down and hold the
▲
and
▼
keys for three
(3) seconds. The display will alternate showing
tunE
and
oFF
.
19. Press and hold down the
*
key and the press the
▲
or
▼
key until the display shows
on
.
Release the keys and the display will alternate between
on
and
tunE
. This indicates that the
controller is going through the autotune process, which can take about 10 minutes. After a
couple of minutes the display will alternate between the current temperature and
tunE
. Once
the cycle has completed the controller will either display the current temperature at or near
the set point or will display the current temperature with
-AL-
to show that it is finishing the
warm up cycle.
20. Adjust the set temperature for the type of bags being tested.
21. After the machine has completely heated and the “READY” light has illuminated, feed some
test bags into the machine and inspect them for quality closures. Refer to the Quality Control
section of this manual to determine proper closures.
8.9 TEMPERATURE
CONTROLLER
The PBC 6000 utilizes a temperature controller that has useful options and controls. The digital
display is easily read and adjustable. To understand more available options, be sure to read the
Instruction Manual found in the electrical enclosure. The instructions in this PBC manual will
only summarize the more utilized functions for a technician and operator.
Within the heater manifold is a thermocouple, monitored by the heat controller. The controller on
the front electrical control panel uses the information from the thermocouple to monitor and adjust
the heater cartridges. To adjust the temperature to the cartridges, use the controller on the
electrical control panel. (
Illustration 8.30
)
Illustration 8.30
Summary of Contents for PBC-6000
