FISCHBEIN PBC-6000, Operator'S Manual, Page: 24 / 82

FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03 24
4.
Turn the pneumatic safety control valve to the OFF position and disconnect the air supply by
releasing the quick disconnect. This allows stored energy to be released from the unit.
5.
Remove all paper scraps, debris and glue from the machine.
8. MAINTENANCE AND ADJUSTMENTS
8.1 SCHEDULED MAINTENANCE
8.1.1 DAILY MAINTENANCE
1. While the front swing channel is in the open position:
A.
Inspect the belts after opening the breakaway assembly. Remove any glue on
the belts with a dull flat edged tool. Be careful not to gouge the surface of the
belts
B.
Remove all paper scraps and debris from the machine.
C.
Remove any glue build-up on the folder, hot air manifold, guides and belts.
2. Open the bleed valve on the pre-filter and filter to remove oil and moisture from the
pneumatic system.
If oil is found in the air supply, this problem must be corrected
immediately. Change filters as needed and regularly.
The PBC 6000 is designed to
use clean, dry, non-lubricated compressed air.
3. Check the compression belt’s tension and adjust if needed.
4. Check the hot air manifold, ensuring the air holes are free of debris.
5. Center the PBC with the conveyor.
6 Replace any burned out lamps.
8.1.2 MONTHLY MAINTENANCE
CAUTION
Turn off and lock out the main switch and the air supply to
the PBC before performing maintenance procedures.
WARNING
OIL IN THE COMPRESSED AIR MAY CAUSE FIRE!
CAUTION
Turn off and lock out the main switch and the air supply to the
PBC before attempting maintenance procedures
.