FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03
48
motor turning the belts. The swing channel must be engaged to properly set the bag
guide components.
Horizontal:
The metal plate of the bag guide should be centered above the centerline where the two
carry through belts come together. The plate is mounted to a 90
o
angle bracket with six
slotted holes. Three holes are used for the horizontal movement and three for the vertical.
To move the guide horizontally, follow these steps:
3. Place a thin ruler or straight edge between the carry through belts below the bag
guide.
4.
Loosen the three bolts (
F
) as shown in
Illustration 8.26
.
5.
Keeping the guide level to the machine, move the guide so that it lines up with the
straight edge.
6. Tighten the bolts (
F
) to secure the bag guide in position. Make sure the guide is
parallel to the infeed top surface.
Vertical:
Attached to the bag guide is a clear shield (bag insertion guide) to help the operator feed the
bag top into the machine at the correct height. The operator should feed bags into the
machine with the top edge of the bag (flap) against the underside of the shield. When these
bags are carried into the creaser area, the bottom of the glue line (region) should be just
above the creaser blade. The glue should not be in the crease of the fold. To adjust the
height of the bag guide, continue to follow these steps:
7. Loosen the three screws, (
K
)
as shown in
Illustration 8.26
.
8. Keeping the guide parallel to
the infeed, move the guide to
the correct height.
9.
Tighten the screws, (
K
) when
the guide is at the correct
height.
Testing:
10. Turn the motor enabled (key)
switch to the “AUTO”
position and push the
“START” button. Make sure
that the heater control is
turned “OFF”.
11. Use test bags fed into the
machine using the bag guide
to determine if the creaser
blade is running along the bag
just below the glue region.
Illustration 8.26 (Top and Front Views)
Summary of Contents for PBC-6000
