FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03
12
3.
Any system that is exported will have a ferrous shroud film or bag covering the unit inside
the box. Simply cut this away and remove. Also, a yellow Zerust
®
vapor capsule (approx.
2.25” x 1.5” x 1.0”) or (57mm x 38mm x 25,4mm) will be attached to a hidden surface of the
frame at its approximate center or a sample of moisture-absorbing powder will be placed in
the bottom of the ferrous film. Find and remove this before continuing to unpack and install
the system.
4.
Remove the lag bolts securing the frame to the crate’s pallet. Locate the box of casters in the
crate and prepare to mount them on the machine.
5.
Use 1000 lb-rated hoist straps and loop them around the overarms of the machine’s frame.
(
Illustration 5.
3) Make sure they are do not pinch and wires or pneumatic hoses. Loop the
straps securely over the forks of a forklift or an overhead hoist.
6.
Use the forklift from the front or back of the machine to raise the machine above the pallet,
just enough to slide the pallet from under the machine. (
Illustration 5.3
) Each side of the
machine must be monitored as the machine is slowly lifted. Monitors must allow the
machine to gently tilt forward, but prevent the machine from swinging.
7.
Remove the pallet, mount the casters (locking casters in the rear) and lower the machine to
the floor.
8.
Roll the machine to the desired work area. Be sure to provide the needed space around the
system as shown in
Illustration 5.1
.
9.
Lock the rear caster wheels once the machine is in place.
10. The swing channel is held in the down position by a holding pin, installed for
shipment only
.
Remove the pin.
The machine should never be operated with the pin installed!
(
Illustration 6.1
)
NOTE:
The front swing channel will rotate open once the pin is
removed.
Once the machine is completely unpacked, inspect it for physical damage or missing components.
Report anything missing or any damages in writing to the shipper and your Fischbein representative.
Zerust is the registered trademark of Northern Technologies International Corporation
Illustration 5.3
Summary of Contents for PBC-6000
