FISCHBEIN PBC-6000, Operator'S Manual, Page: 47 / 82

FISCHBEIN
®
Co. MODEL PBC-6000™
OPERATOR’S MANUAL
REV. D 2005-03 47
After the heights and horizontal adjustments have been completed, the creaser section of the
machine should be tested on empty test bags. If the settings are correct, the bag will enter the
creaser region without jamming and the crease line formed by the blade should be fairly straight.
Some bending will occur in the blade line due to the gussets on the ends of the bags. The flap will
have a few wrinkles in the material, but not large enough to prevent a consistent seal. The bag
should enter the folder smoothly without hanging up.
8.6 BAG GUIDE (MANUAL INFEED)
(F). Glue line adjustment
Once the creaser system has been correctly set, the bag must be fed into the machine at the
correct height in order to crease the bag in the correct location. The creaser blade should be
running along the bag just below the glue line on the flap. (
Illustrations 8.24 and 8.25
)
If your machine is equipped with the manual
infeed, the bag guide above the infeed must
be set at the correct height and angle. The
guide’s height can easily be adjusted
vertically and horizontally to line up the bag
tops with the system. To adjust the bag
guide, follow these steps:
Before making any adjustments to the bag
guide area:
1. Turn “OFF” and lock out the electrical
and pneumatic supplies to the PBC.
2. Turn the Motor Enable (keyed) Switch
(
Illustration 8.5, page 28
) to the center
“STOP” position. This will allow the
swing channel to close without the drive
Illustration 8.24
Illustration 8.25